motrona Encoder Splitters & Signal Converters

Compact DIN-rail module that switches between two SSI absolute encoders and a single target device, so one controller can read either encoder on demand. Ideal for redundant measuring systems and multi-axis setups.

• Selects 1 of 2 SSI encoders for one SSI receiver
• Pluggable screw terminals with status LEDs
• 35 mm DIN-rail mounting

Impulse distributor for incremental encoders with galvanic isolation. Splits one encoder signal into two independent outputs so the same encoder can feed two controllers or drives without interference.

• 1 input, 2 outputs with potential separation
• HTL / TTL / RS422 inputs; output level selectable
• DIP-switch configuration, 10–30 VDC supply

High-capacity impulse distributor that shares one incremental encoder signal across up to eight isolated outputs, each with individually selectable output level. Expandable with ET224 / ET228 extension modules.

• 1 input, 8 isolated outputs (A, /A, B, /B, Z, /Z)
• Up to 1 MHz (RS422/HTL differential), 350 kHz single-ended
• 10–30 VDC supply, DIN-rail housing

Open-frame DIN-rail board that duplicates one encoder signal to two Sub-D outputs. A cost-effective solution where an encoder must feed two devices inside a control cabinet.

• 1 Sub-D input, 2 Sub-D outputs
• 24 V / 5 V supply terminals with fuse protection
• 4-way DIP switch for configuration

Slim DIN-rail converter that adapts incremental encoder signals between TTL / RS422 and HTL levels, letting encoders and controllers with different interface standards work together.

• Level conversion between TTL, RS422 and HTL
• 8-way DIP switch for input/output setup
• Pluggable terminals, power and status LEDs

Front view of the GV210 showing the 8-way DIP switch, 3-pole signal terminal and +/– supply terminal. Compact level converter for incremental encoder signals in industrial automation.

• Clearly labelled front-face terminals
• Configuration by DIP switch – no software needed
• Narrow housing saves DIN-rail space

Right-angled view of the GV210 level converter. Converts encoder signals between TTL / RS422 and HTL for reliable signal transmission between sensors, PLCs and drives.

• TTL / RS422 ↔ HTL conversion
• Power and status LEDs for quick diagnostics
• 35 mm DIN-rail mounting

Panel-type signal splitter that distributes one incremental encoder signal (A, /A, B, /B, Z, /Z) to eight outputs. Input via terminal or Sub-D connector, with a Sub-D cascade port for further expansion.

• 1 input, 8 outputs with per-output level terminal
• Sub-D input and cascade output
• LED status indication, DIP-switch setup

GV4x0 series encoder signal splitter in panel housing. Shares one encoder signal with up to eight controllers, drives or displays — ideal for multi-station machines and production lines.

• 8 pluggable output terminal blocks (Out1–Out8)
• Terminal and Sub-D input, Sub-D cascade output
• 8-way DIP switch configuration

Four-output version of the GV4x0 series splitter. Distributes one incremental encoder signal to four independent outputs in a robust panel housing.

• 4 pluggable output terminal blocks (Out1–Out4)
• Terminal and Sub-D input, Sub-D cascade output
• 8-way DIP switch configuration

Converts SSI absolute encoder data to a 25-bit parallel output in binary, Gray or BCD code. Successor to the IP251, with additional incremental and start-stop inputs.

• SSI input up to 32 bits; inputs up to 1 MHz
• 25-bit push-pull parallel output (binary / Gray / BCD)
• 18–30 VDC supply, USB port, DIN-rail housing